Dell OptiPlex GX260 Bedienungsanleitung PDF herunterladen (Seite 86)

Removing the System Board

5. Place the system board that you just removed next to the replacement system board.

Replacing the System Board

1. Transfer components from the existing system board to the replacement system board.

2. Remove the memory modules and install them on the replacement board.

CAUTION: The microprocessor package and heat-sink assembly can get hot. To avoid burns, be sure that

the package and assembly have had sufficient time to cool before you touch them.

3. Remove the heat-sink assembly and microprocessor

from the existing system board and transfer them to the

replacement system board.

4. Configure the settings of the replacement system board.

5. Set the jumpers

on the replacement system board so it is identical to the one on the existing board.

NOTE: Some components and connectors on the replacement system board may be in different locations than the

corresponding connectors on the existing system board.

6. Orient the replacement board by aligning the notches on the bottom to the tabs on the computer floor.

7. Slide the board toward the back of the computer until it clicks into place.

8. Replace any components and cables that you removed from the system board.

Back to Contents Page

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Keine Kommentare

Dell OptiPlex GX260 Bedienungsanleitung Seite 86