Dell PERC 4/DC Bedienungsanleitung PDF herunterladen (Seite 4)



Cache Memory



64 MB of cache memory resides in a memory bank for PERC 4/SC and 128 MB for PERC 4/DC and PERC 4e/DC. The RAID controller supports write-through or

write-back caching, selectable for each logical drive. To improve performance in sequential disk accesses, the RAID controller uses read-ahead caching by

default. You can disable read-ahead caching.



Onboard Speaker



The RAID controller has a speaker that generates audible warnings when system errors occur. No management software needs to be loaded for the speaker

to work.



Alarm Beep Codes



The purpose of the alarm is to indicate changes that require attention. The following conditions trigger the alarm to sound:

l A logical drive is offline

l A logical drive is running in degraded mode

l An automatic rebuild has been completed

l The temperature is above or below the acceptable range

l The firmware gets a command to test the speaker from an application



Each of the conditions has a different beep code, as shown in Table2-2. Every second the beep switches on or off per the pattern in the code. For example, if

the logical drive goes offline, the beep code is a three second beep followed by one second of silence.



Table 2-2.AlarmBeepCodes



BIOS



For easy upgrade, the BIOS resides on 1 MB flash memory. It provides an extensive setup utility that you can access by pressing <Ctrl><M> at BIOS

initialization to run the BIOS Configuration Utility.



Background Initialization



Background initialization is the automatic check for media errors on physical drives It ensures that striped data segments are the same on all physical drives in

an array.



The background initialization rate is controlled by the rebuild rate set using the BIOS Configuration Utility, <Ctrl><M>. The default and recommended rate is

30%. Before you change the rebuild rate, you must stop the background initialization or the rate change will not affect the background initialization rate. After

you stop background initialization and change the rebuild rate, the rate change takes effect when you restart background initialization.



Wide SCSI.

Ultra320 and Wide SCSI.

Serial port

3-pin RS232C-compatible connector (for

manufacturing use only)

3-pin RS232C-compatible connector (for

manufacturing use only)

3-pin RS232C-compatible connector (for

manufacturing use only)

NOTE: PERC 4 controller cards are not PCI Hot Pluggable. The system must be powered down in order to change or add cards.

Alarm Description

Code

A logical drive is offline.

Three seconds on, one second off

A logical drive is running in degraded mode.

One second on, one second off

An automatic rebuild has been completed.

One second on, three seconds off

The temperature is above or below the acceptable range.

Two seconds on, two seconds off

The firmware gets a command to test the speaker from an application.

Four seconds on

1 2 3 4 5 6 7 8 9 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PERC 4/DC Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Dell PERC 4/DC