Dell G1 Bedienungsanleitung PDF herunterladen (Seite 107)

Installing System Board Options 6-15

)LJXUH'LVFRQQHFWLQJWKH0LFURSURFHVVRU8VLQJWKH7 DEEHG

*XLGH%UDFNHW$VVHPEO\ 

 ,QVHUWWKHQHZPLFURSURFHVVRUDVVHPEO\LQWRWKHFRQQHFW RU

Press the SEC release latches outward until they snap into position. Orient the

assembly with the heat sink facing toward the right (as you face the front of the

chassis), and press the SEC cartridge firmly into its connector until fully seated.

You must use up to 25 pounds of force to fully seat the microprocessor assembly

in the connector.

 ,IWKHJXLGHEUDFNHWDVVHPEO\GRHVQRWKDYHWDEVVHH)LJXUH 

VOLGHWKHKHDWVLQNFOLSVEDFNLQWRSRVLWLRQ

 ,I\RXUXSJUDGHNLWLQFOXGHVDQDLUIORZVKURXGLQVWDOOLWRYHUWKH6(&

FDUWULGJHKHDWVLQNDVVHPEO\

Fit the mouth of the shroud into the alignment slots on the sides of the cooling

fan. Then squeeze the tabs on the top of the shroud and lower the shroud down

until the clips under the tabs engage onto the top of the heat sink.

 ,IQHFHVVDU\FKDQJHWKHPLFURSURFHVVRUVSHHGMXPSHUVHWWLQJVHH

)LJXUHWRORFDWHWKHV\VWHPERDUGMXPSHUV

The microprocessor speed jumper should be set for the installed micro-

processor’s rated internal speed. For example, for a 333-megahertz (MHz) Intel

Pentium II processor, a jumper plug should be installed on the pins labeled

“333MHZ.” (See Table 5-1 for more information.)

tabbed guide-bracket

assembly

tabs (2)

connector

heat sink

SEC cartridge

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 159 160

Keine Kommentare

Dell G1 Bedienungsanleitung Seite 107