Dell G1 Bedienungsanleitung PDF herunterladen (Seite 33)

Using the System Setup Program 2-1

&+$37(5

8VLQJWKH6\VWHP6HWXS3URJUDP

Each time you turn on your computer system or press the reset button, the system

compares the hardware installed in the system to the hardware listed in the system

configuration information stored in nonvolatile random-access memory (NVRAM) on

the system board. If the system detects a discrepancy, it generates error messages

that identify the incorrect configuration settings. The system then prompts you to

enter the System Setup program to correct the setting.

You can use the System Setup program as follows:



To change the system configuration information after you add, change, or remove

any hardware in your system



To set or change user-selectable options—for example, the time or date on your

system

You can

view

the current settings at any time. When you

change

a setting, in many

cases you must reboot the system before the change takes effect.

After you set up your system, run the System Setup program to familiarize yourself

with your system configuration information and optional settings. Dell recommends

that you print the System Setup screens (by pressing the <Print Screen> key) or write

down the information for future reference.

Before you use the System Setup program, you need to know the kind of diskette

drive(s) and hard-disk drive(s) installed in your computer. If you are unsure of any of

this information, see the Manufacturing Test Report that was shipped with your sys-

tem and is located in the Dell Accessories folder.

(QWHULQJWKH6\VWHP6HWXS3URJUDP

Enter the System Setup program as follows:

 7XUQRQ\RXUV\VWHP

If your system is already on, shut it down and then turn it on again.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 159 160

Keine Kommentare

Dell G1 Bedienungsanleitung Seite 33