Dell Brocade M5424 Bedienungshandbuch PDF herunterladen (Seite 83)

Installing An I/O Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

NOTE: The I/O module must be installed in the appropriate I/O bay.

1. Unpack the I/O module and prepare it for installation.

For instructions, see the documentation that accompanied the I/O module.

2. Remove the I/O connector cover from the back of the module.

3. Lift the handle release latch and open the I/O module handle.

4. Slide the module into the enclosure.

5. Close the handle until it snaps securely into place and the module is fully seated.

6. Connect all cables that must be attached to the I/O module.

See the documentation provided with the I/O module for information about its cable connections. For more

information on using the cable enumerators to organize and manage the cables, see the

Rack Installation Guide

support.dell.com/manuals.

7. A matching fabric mezzanine card must be installed in one or more blades to support the new I/O module. If

necessary, install the mezzanine card(s).

Enclosure Bezel

Removing The Enclosure Bezel

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

1. Press the power switch on the enclosure to turn off the system.

2. Rotate the LCD module so that the underside of the module faces upward.

3. Remove the cable cover and disconnect the ribbon cable from the LCD module.

4. Remove the Torx T8 and Torx T20 screws that secure the bezel to the enclosure.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 98 99

Keine Kommentare

Dell Brocade M5424 Bedienungshandbuch Seite 83