Dell Broadcom NetXtreme Family of Adapters Betriebsanweisung PDF herunterladen (Seite 185)

User Guide NetXtreme II

September 2013

Broadcom Corporation

Document INGSRVT78-CDUM100-R Removing the Device Drivers Page 185

with the Broadcom Advanced Control Suite 3 (BACS) application in

HKLM\Software\Mictrosoft\Windows\CurrentVersion\Uninstall for the correct hexidecimal number.

To perform a silent reinstall of the same installer

Type the following:

setup /s /v"/qn REINSTALL=ALL"

NOTE: The REINSTALL switch should only be used if the same installer is already installed on the system. If

upgrading an earlier version of the installer, use setup /s /v/qn as listed above.

To perform a GUI reinstall of the same installer

Type the following:

setup /V"REINSTALL=ALL"

If performing a silent upgrade or uninstall, ensure to do a manual reboot afterwards to avoid leaving the system in an

inconsistent state.

During silent upgrade or uninstall, your system may reboot automatically. If you wish to suppress the reboot, please append

REBOOT=ReallySuppress to the end of the corresponding upgrade or uninstall command listed above.

In some circumstances, reboot is required before uninstallation can continue. If you used REBOOT=ReallySuppress to

suppress the reboot, the uninstallation may be suspended. You will need to reboot manually for the uninstallation to continue.

To perform a silent install and create a log file at (f:\1testlog.txt)

setup /s /v”/qn /L f:\1testlog.txt”

REMOVING THE DEVICE DRIVERS

NOTE: Windows Server 2008 and Windows Server 2008 R2 provide the Device Driver Rollback feature to replace

a device driver with one that was previously installed. However, the complex software architecture of the NetXtreme

II device may present problems if the rollback feature is used on one of the individual components. Therefore, we

recommend that changes to driver versions be made only through the use of a driver installer.

To remove the device drivers

1. In Control Panel, double-click Add or Remove Programs.

2. Click Broadcom NetXtreme II GigE Driver Installer, and then click Remove. Follow the onscreen prompts.

3. Click Yes to restart your system.

- or -

4. Click No to restart your system at a later time. Click OK to acknowledge that the installation has been suspended. The

uninstallation of the driver is postponed until the next restart of your system.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 331 332

Keine Kommentare

Dell Broadcom NetXtreme Family of Adapters Betriebsanweisung Seite 185