Dell PowerEdge M910 Bedienungsanleitung PDF herunterladen (Seite 6)

6 Processor Installation

Installing a Processor

WARNING: Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this

procedure, review the safety instructions that came with the system.

NOTE: In a single-processor configuration, the CPU1 socket must be used.

If you are adding a second processor for the first time, remove the heat-

sink blank and the processor blank from the vacant processor socket.

Removing the blank is similar to removing a processor. See "Removing a

Processor".

Remove the processor from the packing material by the processor’s edges

only. Do not touch the bottom of the processor. Handle the processor

carefully with your fingers on the side edges. Place your hand beneath the

processor when you are moving it to the system.

Locate the pin 1 indicator on the system board socket.

Locate the pin 1 indicator on the top of the processor. The pin 1 indicator

is shown as a triangle on the top of the processor. See Figure 1-4.

CAUTION: Positioning the processor incorrectly can permanently damage

the system board or the processor. Be careful not to bend the pins in the socket.

Place the processor over the socket with each pin 1 aligned and level.

See Figure 1-3 and Figure 1-4.

CAUTION: Do not use force to seat the processor. When the processor is

positioned correctly, it engages easily into the socket.

6 Align the notches in the

rocessor with the

socket keys on t

he ZIF

socket. See

Figure 1-4.

nstall the processor in the socket. Keep the processor level

(see Figure 1-3) and insert it straight down into the socket.

Allow the

processor to float on the pins, allowing the processor shield to hold it

in place.

1 2 3 4 5 6 7 8 9 10 11 ... 69 70

Keine Kommentare

Dell PowerEdge M910 Bedienungsanleitung Seite 6