Dell PowerEdge M610x Bedienungsanleitung PDF herunterladen (Seite 264)

264 Installing Blade Components

Installing an HT Bridge Card

Perform the following steps to prepare the two sockets on the new system

board:

Remove the processor filler blank.

Lift the plastic processor socket cover from the socket.

Unlatch and rotate the socket-release lever 90 degrees upward.

Lift the processor shield.

Repeat step a through step d to prepare the second processor socket.

Install the bridge card in the socket. See Figure 3-54.

CAUTION: Positioning the card incorrectly can permanently damage the card and

the system board when you turn the system on. Be careful not to bend the pins on

the LGA socket.

Identify the pin-1 corner of the card by locating the tiny gold triangle

on one corner of the card. Place this corner in the same corner of the

ZIF socket identified by a corresponding triangle on the system board.

Ensure that the socket-release lever is fully open.

With the pin-1 corners of the card and socket aligned, set the

processor lightly in the socket.

Because the system uses a ZIF processor socket, do not use force.

When the card is positioned correctly, it drops down into the socket

with minimal pressure.

Close the processor shield.

Rotate the socket release lever down until it snaps into place, securing

the card.

Close the blade. See "Closing the Blade" on page 161.

Install the blade. See "Installing a Blade" on page 158.

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 367 368

Keine Kommentare

Dell PowerEdge M610x Bedienungsanleitung Seite 264