Back to Contents Page
Processor
Dell™OptiPlex™GX60SystemsUser'sGuide
1. Follow the procedures in "Before You Begin."
2. Disconnect the cooling fan power cable from the FAN connector on the system board.
3. Disconnect the 12-volt power cable from the 12VPOWER connector on the system board.
4. Remove the heat sink/blower assembly:
a. The heat sink is attached to the blower. Press and lower the green lever on the retention mechanism until it is parallel to the system board.
b. Gently rock the heat sink, and then slightly twist it as you lift it from the processor.
5. Lift the heat sink/blower assembly away from the processor.
6. Remove the two screws on the blower to remove it from the heat sink.
7. Pull the release lever straight up until the processor is released, and then remove the processor from the socket.
NOTICE: Do not discard the blower. You will reuse it. If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not
installing a processor upgrade kit from Dell, reuse the original heat sink when you install your new processor.
Kommentare zu diesen Handbüchern