Dell Powervault NX400 Bedienungsanleitung PDF herunterladen (Seite 70)

If you are installing a second power supply, remove the power supply blank in the bay by pulling outward on the

blank.

Figure 32. Removing and Installing the Power Supply Blank

1. power supply blank

Installing The Power Supply Blank

NOTE: Install the power supply blank only in the second power supply bay.

To install the power supply blank, align the blank with the power supply bay and insert it into the chassis until it clicks

into place.

System Battery

Replacing The System Battery

WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with

the same or equivalent type recommended by the manufacturer. See your safety information for additional

information.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your

warranty. Read and follow the safety instructions that came with the product.

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and

peripherals.

2. Open the system.

3. Remove the cooling shroud.

4. Locate the battery socket.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 122 123

Keine Kommentare

Dell Powervault NX400 Bedienungsanleitung Seite 70