Dell PowerVault NX3200 Bedienungsanleitung PDF herunterladen (Seite 9)

About Your System

Front-Panel Features And Indicators

Figure 1. Front-Panel Features and Indicators

Item Indicator, Button, or

Connector

Icon Description

1 Diagnostic indicators The diagnostic indicators light up to display error status.

2 System identification button The identification buttons on the front and back panels

can be used to locate a particular system within a rack.

When one of these buttons is pressed, the system status

indicator on the back flashes until one of the buttons is

pressed again.

Press to toggle the system ID on and off.

If the system stops responding during POST, press and

hold the system ID button for more than five seconds to

enter BIOS progress mode.

To reset the iDRAC (if not disabled in F2 iDRAC setup)

press and hold the button for more than 15 seconds.

3 Power-on indicator, power

button

The power-on indicator lights when the system power is

on. The power button controls the power supply output to

the system.

NOTE: On ACPI-compliant operating systems, turning

off the system using the power button causes the

system to perform a graceful shutdown before power

to the system is turned off.

4 NMI button Used to troubleshoot software and device driver errors

when running certain operating systems. This button can

be pressed using the end of a paper clip.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 132 133

Keine Kommentare

Dell PowerVault NX3200 Bedienungsanleitung Seite 9