Dell PowerVault NX3200 Bedienungsanleitung PDF herunterladen (Seite 44)

NOTE: Retain removed memory-module blank(s) for future use.

CAUTION: Handle each memory module only on either card edge, making sure not to touch the middle of the

memory module.

6. Align the memory module's edge connector with the alignment key of the memory module socket, and insert the

memory module in the socket.

NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket

in only one way.

7. Press down on the memory module with your thumbs until the socket levers latch into a locked position.

When the memory module is properly seated in the socket, the levers on the memory module socket align with the

levers on the other sockets that have memory modules installed.

8. Repeat step 4 through step 7 of this procedure to install the remaining memory modules.

9. Replace the cooling shroud.

10. Close the system.

11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

12. Press <F2> to enter the System Setup, and check the memory settings.

The system should have already changed the value to reflect the newly installed memory.

13. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat step 4 through

step 7 of this procedure, checking to ensure that the memory modules are firmly seated in their sockets.

14. Run the appropriate diagnostic test. For more information, see Using System Diagnostics.

Hard Drives

All hard drives connect to the system board through the hard-drive backplane. Hard drives are supplied in hot-

swappable hard-drive carriers that fit in the hard-drive slots.

CAUTION: Before attempting to remove or install a hard drive while the system is running, see the documentation

for the storage controller card to ensure that the host adapter is configured correctly to support hot-swap hard

drive removal and insertion.

CAUTION: Do not turn off or reboot your system while the hard drive is being formatted. Doing so can cause a hard

drive failure.

NOTE: Use only hard drives that have been tested and approved for use with the hard-drive backplane.

When you format a hard drive, allow enough time for the formatting to be completed. Be aware that high-capacity hard

drives can take a number of hours to format.

Removing A 2.5 Inch Hard-Drive Blank (Back)

CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks installed.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 132 133

Keine Kommentare

Dell PowerVault NX3200 Bedienungsanleitung Seite 44