Dell M20 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 13)



8. Lift the display assembly out of the computer base.



Installing the Display Assembly



1. Align the display assembly over the screw holes in the base of the computer.



2. Replace the four M2.5 x 5-mm screws.



3. Route the two antenna cables under the routing clips.



4. Replace the keyboard.



5. Replace the center control cover.

Display Bezel



Removing the Display Bezel



1. Follow the instructions in "Preparing to Work Inside the Computer."



2. Remove the center control cover.



3. Remove the keyboard.



4. Remove the display assembly.



5. Use a plastic scribe to pry the six display bumpers out of the screw holes located on the front of the bezel.



6. Remove the six M2.5 x 5-mm screws located on the front of the bezel.

NOTE: Ensure that you route the antenna cables under the routing clips. Failure to do so could result in your keyboard not seating properly.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell M20 Anleitung zur Fehlerbehebung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kabelverbinder Dell M20