Dell Force10 E300 Betriebsanweisung PDF herunterladen (Seite 4)

TeraScale to ExaScale Upgrade Procedure 4

Automatic upgrade for one or more new SFMs

The FPGA auto upgrade takes place when any newly inserted SFM runs an FPGA version lower than the version

running on the SFMs in the chassis. During this auto upgrade process, the system displays messages relaying the

status of the upgrade process (Figure 2). To verify the result of the individual SFM version upgrade, use the

show

sfm slot

command.

Figure 2 New SFM Automatic Upgrade Messages

**************************************************************************

* Warning !!! Warning !!! Warning !!!

* -----------------------------------------------------------------------

* Starting auto upgrade of SFMs to newer version 0x0.0.3

* Please wait until upgradation of 1 SFM is complete.

* SFM will reset itself after upgradation of 1 SFM is complete !

**************************************************************************

SFM 0/9 upgrade started

SFM 0/9 is upgraded to revision 0x0.0.3.

*************************************************************

* Warning !!! Warning !!! Warning !!!

* -----------------------------------------------------------

* Auto upgrade on 1 SFM to version 0x0.0.3 is complete.

* Resetting SFM .... Please wait ....!!!

*************************************************************

SFM 0/9 reset started

00:08:29: %RPM1-P:CP %TSM-6-SFM_USR_RESET: SFM 0 reset by user

reset SFM 0 successful !

*************************************************************

* Warning !!! Warning !!! Warning !!!

* -----------------------------------------------------------

* Resetting on 1 SFM to revision 0x0.0.3 is complete !

*************************************************************

1 2 3 4 5 6 7 8

Keine Kommentare

Dell Force10 E300 Betriebsanweisung Seite 4