Dell Active Fabric Manager Betriebsanweisung PDF herunterladen (Seite 13)

Using VDS CLI

The following list describes the VDS CLI modes:

NOTE: You can enter a question mark after the command prompt in any mode to view a list of available commands.

You can also enter the exit command to exit the current mode (or the application, if you are in DEFAULT mode).

• DEFAULT mode — This is the default mode when you log in. In DEFAULT mode, the command prompt ends with >.

The following commands are available in DEFAULT mode:

– enable

– vds

– exit

NOTE: If you use the exit command in DEFAULT mode, the application closes.

• ENABLE mode — This mode enables additional commands, including the config command. To enter ENABLE

mode, use the enable command. In ENABLE mode, the command prompt ends with #.

NOTE: No password is required to enter ENABLE mode.

The following commands are available in ENABLE mode:

– config

– passwd

– settings

– show vds

– vds

– wizard

– exit

• CONFIG mode — This mode allows you to configure VDS settings. To enter CONFIG mode, use the config

command. In CONFIG mode, the command prompt ends with (config)#.

The following commands are available in CONFIG mode:

– config

– find ip

– find mac

– find vm

– port

– portgroup

– show interface

– show interface brief

– show lldp

– show lldp interface

– show netflow

Using VDS CLI

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Keine Kommentare

Dell Active Fabric Manager Betriebsanweisung Seite 13