Dell Force10 C150 Spezifikationen

Installing and Maintainingthe C150 System

10 | Overviewwww.dell.com | support.dell.comC150 System Installation Process OverviewThe Dell Force10 recommended installation process is summarized b

Preparing the Site | 113Preparing the SiteSite Selection CriteriaBefore beginning the installation process, make sure that the area where you intend t

12 | Preparing the Sitewww.dell.com | support.dell.comPower RequirementsThe C150 needs at least one power supply to operate. However, Dell Force10 rec

Installing the C150 Chassis | 134Installing the C150 ChassisSafety Considerations NOTE: Use an equipment lift or pallet jack when lifting or moving t

14 | Installing the C150 Chassiswww.dell.com | support.dell.comInstalling the Chassis into an Equipment RackFollow these steps to install the chassis

Installing the C150 Chassis | 154 Insert screws (provided with your rack) through the chassis rack-mounting bracket and into the equipment rack, and t

16 | Installing the C150 Chassiswww.dell.com | support.dell.com

RPMs and Line Cards | 175RPMs and Line CardsThe C150 system accommodates four line cards and two Route Processor Modules (RPMs).Route Processor Module

18 | RPMs and Line Cardswww.dell.com | support.dell.comLine CardsLine cards are hot-swappable. Any line card can be inserted into any line card slot.

RPMs and Line Cards | 19Installing RPMs and Line Cards WARNING: Always wear an ESD-preventive wrist or foot-heel ground strap when handling RPMs or l

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

20 | RPMs and Line Cardswww.dell.com | support.dell.com5 Rotate the levers toward the card to seat the backplane connectors and line card in place. Pu

RPMs and Line Cards | 21Figure 5-5. Installing a Line CardFigure 5-6. Installing an RPMCard LeverCard GuidefnD0004mpCard LeverInstall fan tray befor

22 | RPMs and Line Cardswww.dell.com | support.dell.comRemoving RPMs and Line Cards WARNING: After removing an RPM, place a panel blank in the empty

Management Cable Pinout | 236Management Cable PinoutConnecting the Console PortThe console port is an asynchronous serial port. If you connect a devic

24 | Management Cable Pinoutwww.dell.com | support.dell.comAccessing the Console with a DB-9 AdapterYou can connect to the console using an RJ-45 to R

AC Power Supply Units | 257AC Power Supply UnitsThe C150 has six power supply slots at the bottom front of the chassis (Figure 7-1). • The C150 requir

26 | AC Power Supply Unitswww.dell.com | support.dell.comFigure 7-2. AC Power SupplyEach AC power supply has one LED as described in Table 7-1. This

AC Power Supply Units | 27The chassis transmits power to connected IEEE 802.3af-compliant devices through ports that are enabled with PoE. A minimum o

28 | AC Power Supply Unitswww.dell.com | support.dell.comRemoving AC Power Supply Units NOTE: Do not remove a panel blank unless you are ready to ins

Installing DC Power Entry Modules | 298Installing DC Power Entry ModulesThe C150 has six power supply slots at the front-bottom of the chassis (Figure

Contents | 3Contents1 About this GuideInformation Symbols and Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

30 | Installing DC Power Entry Moduleswww.dell.com | support.dell.com• Rated for 60A service to allow for a fully loaded C150 system per NEC in the Un

Installing DC Power Entry Modules | 31Step Task (continued)4 Slide the PEM into either power slot 0 or 2 (see (Figure 8-2). If you are installing redu

32 | Installing DC Power Entry Moduleswww.dell.com | support.dell.comFigure 8-3. Grounding8 Connect the -48 VDC and Return cables from each PEM to th

Installing DC Power Entry Modules | 33Status LEDThe status LED indicates the condition of the PEM.Removing a DC PEMThe left chassis PEM slot is labell

34 | Installing DC Power Entry Moduleswww.dell.com | support.dell.com

Powering Up | 359Powering UpBefore you supply power to the chassis, Dell Force10 recommends that you re-inspect your equipment rack and chassis. Verif

36 | Powering Upwww.dell.com | support.dell.comTo power down a power supply or the entire C150 system:After you supply power to the system, the follow

Powering Up | 37Figure 9-1. Boot Process Complete .*************.

38 | Powering Upwww.dell.com | support.dell.com

Fan Tray | 3910Fan TrayThe C150 chassis contains one field-replaceable fan tray. There are two types of fan tray that may be installed: Fan Tray CC-C1

4 | Contentswww.dell.com | support.dell.com8 Installing DC Power Entry ModulesRecommended Normal Operating Conditions . . . . . . . . . . . . . . . .

40 | Fan Traywww.dell.com | support.dell.comInstalling the Fan TrayTo install the fan tray: NOTE: The fan tray LED remains lit when the chassis is po

Removing and Replacing Components | 4111Removing and Replacing ComponentsThis section provides instructions for removing and replacing the following C

42 | Removing and Replacing Componentswww.dell.com | support.dell.comRemoving and Replacing Power Supply Units WARNING: Do not remove a panel blank u

Removing and Replacing Components | 43To remove and replace C150 line cards:Removing and Replacing an RPM WARNING: After removing an RPM, place a pan

44 | Removing and Replacing Componentswww.dell.com | support.dell.com2 Extend the left and right card levers by first pressing gently down on the thum

System Boot | 4512System Boot When you supply power to the C150 system, the system performs a series of power-on self-tests. RPM and line card status

46 | System Bootwww.dell.com | support.dell.comCommand Purpose helpor?• Enter help or? to display a list of available commands and syntax.• Enter synt

System Boot | 47 show bootvar This command displays the current operating system boot configuration parameters. show bootflash This command displays

48 | System Bootwww.dell.com | support.dell.comRefer to the FTOS Command Line Interface Reference for BOOT_USER mode commands and commands for run-tim

The Compact Flash Card | 4913The Compact Flash CardEach RPM is designed with a slot (slot0:) to accommodate a Compact Flash card (external Compact Fla

Contents | 5Contacting Technical SupportThe iSupport Website . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

50 | The Compact Flash Cardwww.dell.com | support.dell.comTo remove the flash memory card:Formatting the Compact Flash CardNew Compact Flash cards mus

Alarms | 51AAlarmsThe C150 system generates alarms for the following conditions:• fan tray status• power supply status• RPMs status• high temperature

52 | Alarmswww.dell.com | support.dell.comAC Power Supplies and AlarmsDuring system boot, if a redundant power supply is removed or fails, FTOS genera

System Specifications | 53BSystem SpecificationsThis appendix contains the following major sections:• Physical Design• System Power Specifications on

54 | System Specificationswww.dell.com | support.dell.comFigure B-1. Chassis Dimensions Length/WidthfnD0012mp15.7 inches17.5 inches

System Specifications | 55Figure B-2. Chassis Dimensions DepthfnD0011mp15.5 inches

56 | System Specificationswww.dell.com | support.dell.comSystem Power SpecificationsComponent Power Requirements NOTE: The listed requirement for the

System Specifications | 57USA FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT — This equipment has been tested and found to comply with the limits f

58 | System Specificationswww.dell.com | support.dell.com — This is Class A product based on the standard of the Voluntary Control Council For Interf

System Specifications | 59• EN 60825-1 Safety of Laser Products—Part 1: Equipment Classification Requirements and User’s Guide• EN 60825-2 Safety of L

6 | Contentswww.dell.com | support.dell.com

60 | System Specificationswww.dell.com | support.dell.comFigure B-3. The European WEEE Symbol In accordance with the European WEEE Directive, electri

Contacting Technical Support | 61CContacting Technical Support The iSupport WebsiteiSupport provides a range of documents and tools to assist you with

62 | Contacting Technical Supportwww.dell.com | support.dell.comLocating Serial Numbers• The chassis serial number is below the barcode on the sticker

Contacting Technical Support | 633 When returning an RMA component, follow the packing and shipping directions in the Return Instructions document tha

64 | Contacting Technical Supportwww.dell.com | support.dell.com

www.dell.com | support.dell.comPrinted in the U.S.A.

About this Guide | 71About this GuideThis guide provides site preparation recommendations and instructions for installing the Dell Force10 C150 chassi

8 | About this Guidewww.dell.com | support.dell.com ATTENTION: Pour ce qui est de la protection contre les courts-circuits (surtension), ce produit

Overview | 92OverviewThe C150 is a high performance switch/router. This 6-slot system contains two slots for Route Processor Modules (RPMs) and four s