Dell Z9000 Spezifikationen

Dell Force10 Z9000 SystemQuick Start GuideRegulatory Model: Z9000

8 Installing the HardwareSplitting QSFP Ports to SFP+ PortsThe Z9000 supports splitting a single 40G QSFP port into four 10G SFP+ ports using one of t

Installing the Hardware 9Power Up SequenceSupply Power and Power Up the SystemDell Force10 recommends re-inspecting your system prior to powering up.

10 Installing the HardwareAs soon as the cable is connected between the Z9000 and the power source, the chassis is powered-up; there is no on/off swit

Installing the Hardware 11Environmental ParametersAC Power RequirementsDC Power RequirementsPower SuppliesThe Z9000 is designed to support two hot-swa

12 Installing the Hardware CAUTION: Remove the power cable from the modules prior to removing the module itself. Power must not be connected prior to

Installing the Software 132Installing the SoftwareNavigating CLI ModesThe FTOS prompt changes to indicate the CLI mode. You must move linearly through

14 Installing the SoftwareAccessing the RJ-45 console port with a DB-9 adapterYou can connect to the console using an RJ-45 to RJ-45 rollover cable an

Installing the Software 15Default ConfigurationA version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the chassis, however the syste

16 Installing the SoftwareAccess the System RemotelyYou can configure the system to be accessed remotely by Telnet. The Z-Series has a dedicated manag

Installing the Software 17Configure a Username and PasswordConfigure a system username and password to access the system remotely.Configure the Enable

18 Installing the SoftwareCreate a Port-based VLANThe Default VLAN as VLAN 1 is part of the system startup configuration and does not require configur

Installing the Software 19Assign an IP Address to a VLAN NOTE: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To

20 Installing the Software

www.dell.com | support.dell.comPrinted in the U.S.A.

Dell Force10 Z9000 SystemQuick Start GuideRegulatory Model: Z9000

Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indic

About this Guide 3About this GuideThis document is intended as a Quick Start Guide to get new systems up and running and ready for configuration. For

4 About this Guide

Installing the Hardware 51Installing the HardwareThis guide assumes all site preparation has been performed before installing the chassis.Installing t

6 Installing the HardwareInstall chassis into rack or cabinetAttach a Ground CableUse a single M4x0.7 screw for attaching a ground cable to the chassi

Installing the Hardware 7 NOTE: Coat the one-hole lug with an anti-oxidant compound prior to crimping. Bring any un-plated mating surfaces to a shiny