Dell PowerEdge M IO Aggregator Schnellstart Anleitung Seite 1

Dell PowerEdge FN 410S I/O Aggregator Getting Started Guide

from a console terminal connected to the port through the provided serial cable (with USB UART-A to back-plane to CMC).The console port supports async

NOTE: When the ingress air temperature exceeds 60°C, the Status LED turns Amber and a major alarm is triggered.Table 3. SFP+ Port LEDsPort LED LED Co

12

4InstallationThis switch installation procedure assume the Dell PowerEdge FX2 server chassis is installed correctly. For complete instructions for ins

14

5Installing and Configuring the AggregatorAfter you unpack the aggregator, refer to the following flowchart for an overview of the steps you must foll

Installing a switch in a Dell PowerEdge FX2 Server ChassisAfter you unpack the aggregator, slide the switch into one of the open I/O module slots in t

b. Set the data rate to 115200 baud.c. Set the data format to 8 data bits, 1 stop bit, and no parity.d. Set the flow control to none.e. Set the termin

By default, the aggregator receives IP addresses from a DHCP server in the network. If you want to change the DHCP default setting, obtain the require

7. By default, the IP address and subnet mask of the out-of-band management interface used for remote SNMP or Telnet access is assigned by a DHCP serv

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

• FCoE initiation protocol (FIP) snooping.• Hybrid ports: Ports are administratively up and auto-configured to operate as hybrid ports to transmit tag

brought down after the specified defer-timer interval, which is 10 seconds, by default. If you have configured VLAN, you can reduce the defer time by

• To restore the default Auto-VLAN mode of operation (in which all ports are members of all 4094 VLANs) on a port, enter the auto vlan command:Dell(co

6Assembling a VLTAfter you complete the initial configuration, the aggregator is powered up and operational.VLT is limited to two aggregators of the s

b. Connect the cable to the port 9 on the next aggregator.NOTE: The resulting topology allows the VLT to function as a PRIMARY/SECONDARY switch with L

7Programmable-MUX ModeStandalone MUX is the zero-touch auto-configuration default mode of the aggregator. If you want the flexibility to configure dif

26

8Next StepsYou can customize the aggregator for use in your data center network. To perform additional switch configuration, do one of the following:•

28

9Technical SpecificationsThe aggregator is an I/O module and installed with the Dell PowerEdge FX2 server chassis for communication.NOTE: Replace the

Contents1 About this Guide...52 Introduction...

7 Programmable-MUX Mode... 25Configuring and Bringing Up the Programmab

1About this GuideThis document helps you in getting started with Dell PowerEdge FN 410S I/O Aggregator. For complete installation and configuration in

6

2IntroductionThis document provides basic information about the Dell PowerEdge FN 410S I/O Aggregator, including how to install and perform the initia

8

3Hardware OverviewThis section contains information about input/output aggregator (IOA) characteristics and modular hardware configurations.Internal P