Dell Networking S6000 Schnellstart Anleitung PDF herunterladen (Seite 18)

14 Installation

Installing an AC or DC Power Supply

To install an AC or DC power supply, follow these steps.

NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot as

this may damage the PSU or the S6000 chassis.

NOTE: Ensure that the PSU is correctly installed. When the PSU is correctly

installed, the power connector is on the left side of the PSU and the status LED is at

the bottom of the PSU.

NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell

Networking recommends using power supply 1 (PSU1) as the blank plate slot.

Remove the PSU slot cover from the S6000 (the PSU side of switch). You

may select either of the two PSU slots.

Remove the PSU from the electro-static bag.

Insert the PSU into the switch PSU slot (insert the PSU exposed PCB edge

connector first).The PSU slot is keyed such that the PSU can only be fully

inserted in one orientation.

1 - Slot 1

2 - PSU1

When the PSU is installed correctly, it snaps into place and is flush with the

back of the switch.

Plug in the appropriate cord (AC 3 prong or DC wiring) from the switch PSU

to the external power source (either an AC wall outlet or a DC rack bus bar).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Keine Kommentare

Dell Networking S6000 Schnellstart Anleitung Seite 18