Dell Compellent Series 40 Einstellungsanleitung PDF herunterladen (Seite 9)

2 Setting Up the Storage Center

Setting Up a Controller

Once hardware has been racked and cabled and any FC switches that provide server

connectivity have been configured and zoned, you configure and identify a controller.

Configuring a controller includes the following tasks:

• Connect to a Controller on page 3

• Reset Hardware and System Serial Numbers on page 4

• Set IP Addresses on page 5

If you have a dual-controller system, you will configure both controllers using the serial

connection. For documentation purposes we call the controller you assign the lower serial

number as Controller 1 and the other as Controller 2. Configure Controller 1 and then

configure Controller 2.

Connect to a Controller

 To connect to a controller

1 Using a DB9 cable, connect a PC or laptop to a Storage Center controller DB9 serial

port. (To connect from a USB port, use a USB to DB9 converter.)

2 Power up the PC.

3 Open a terminal emulator or a command line interface. Configure the connection as

follows:

Setting Value

Emulation VT220

Column Mode 132

Line Wrapping Off

Connection Serial Port

Connection Type Direct

Baud Rate 115,200

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

Keine Kommentare

Dell Compellent Series 40 Einstellungsanleitung Seite 9