
PowerConnect 3324/3348 Release Notes
Console port speed not displayed with
"show line console command"
Console speed not displayed when "show line console" command is entered from
the CLI interface.
Port Mirroring
Title Description
Gigabit ports mirroring in stacking mode In cases where both source and destination ports are Gigabit ports, some of the
packets may be dropped due to the stacking management traffic.
Tagged traffic in port mirroring All traffic on the mirroring target port is always tagged (even if originally it was sent
untagged).
Mirroring of PAUSE frames Destination port does not receive PAUSE frames.
Broadcast Storm Control
Title Description
Storm control on G2 port Since the G2 stacking port is used for internal management traffic, storm control is
disabled on the G2 stacking port.
Link Aggregation (LAG)
Title Description
Joining a port to a LAG Joining a port to a LAG is possible only if:
•
•
•
•
•
•
•
•
There is no Layer 3 interface defined on the port.
The port does not belong to any VLAN.
The port does not belong to any other LAG.
The port is not a mirrored port.
The port 802.1p priority is equal to LAGs 802.1p priority.
An ACL is not defined on the port.
QoS Trust is disabled on the port.
GVRP is not enabled on the port.
Port in LAG MAC addresses learning When a port is a member of LACP LAG under traffic, MAC addresses are learned
on the port until it actually joins to the LAG.
Rapid Spanning Tree (RSTP)
Title Description
RSTP port roles indications
The command show spanning-tree interface does not show RSTP port roles, nor does
the Web-based management.
Layer3
IP
Title Description
Ping to self PowerConnect 3348/3348 cannot ping itself.
QoS/ACLQoS
Title Description
Changing priority-queue command
cancels wrr-bandwidth settings
Changing the priority-queue out num-of-queues command value leaves any existing
wrr-bandwidth commands.
Editing ACL from CLI
Once an ACL is bound to an interface it cannot be edited from the CLI
System Firmware Version 1.1.0.42 Page 6
Kommentare zu diesen Handbüchern