Dell PowerVault NX3000 Bedienungsanleitung PDF herunterladen (Seite 80)

80 Installing System Components

CAUTION: Do not turn off or reboot your system while the drive is being formatted.

Doing so can cause a drive failure.

NOTE: Use only drives that have been tested and approved for use with the SAS

backplane board.

When you format a hard drive, allow enough time for the formatting to be

completed. Be aware that high-capacity hard drives can take a number of

hours to format.

Mixed SAS/SATA Hard-Drive Configurations

Mixed hard-drive configurations of SAS and SATA drives are allowed. In this

configuration, two SAS drives must be installed in hard-drive slots 0 and 1

only. The remaining slots can have SATA drives installed.

Removing a Hard-Drive Blank

CAUTION: To maintain proper system cooling, all empty hard-drive bays must

have drive blanks installed.

1 Remove the front bezel. See

Removing the Front Bezel

2 Grasp the front of the hard-drive blank, press the release lever on the

right side, and

slide the blank out until it is free of the drive bay

. See

Figure 3-4

Figure 3-4. Removing and Installing a Hard Drive Blank

1 3.5-inch hard drive blank 2 release latch

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 115 116

Keine Kommentare

Dell PowerVault NX3000 Bedienungsanleitung Seite 80