Dell Precision 220 Bedienungsanleitung PDF herunterladen (Seite 37)

the SCSI device. Connect the other end of the power cable into a standard electrical wall outlet.

Check all other cable connections. Fold all internal cables out of the way to provide airflow for the fan or cooling vents.

6. If you installed an externally accessible device, remove the front-panel insert for the drive bay.

For a mini tower chassis, you must first remove the front panel as described in "Removing and Replacing the Front Panel." To remove a

front-panel insert, hold the front panel (mini tower chassis) or computer cover (desktop chassis) with the inside facing toward you and press

each end of the insert with your thumbs until it snaps free of the front panel or computer cover. If you have a mini tower chassis, replace the

front panel.

7. Replace the computer cover. Then reconnect your computer and peripherals to their power sources, and turn them on.

8. To reset the chassis intrusion detector, enter System Setup, select System Security, and reset Chassis Intrusion to Enabled or

Enabled-Silent.

See "Chassis Instrusion" for instructions.

9. If necessary, update the drive system configuration information in System Setup.

After installing a SCSI hard-disk drive, Primary Drive 0andPrimary Drive 1 should be set to None. If you have any EIDE devices on the

second EIDE channel, such as a CD-ROM or tape drive, Secondary Drive 0and/orSecondary Drive 1 should be set to Auto. If you have

any SCSI devices on the second EIDE channel, Secondary Drive 0and/orSecondary Drive 1 should be set to None.

10. If you installed a SCSI hard-disk drive, partition and format the drive. Then install the operating system.

For instructions, see "Partitioning and Formatting SCSI Hard-Disk Drives" and your operating system documentation.

11. Test the SCSI devices.

Test a SCSI hard-disk drive by running the Dell Diagnostics.

To test a SCSI tape drive, refer to the documentation for the tape drive software to perform a tape drive backup and verification test.

Partitioning and Formatting SCSI Hard-Disk Drives

You may need to use different programs than those provided with the operating system to partition and format SCSI hard-disk drives. Refer to the

documentation that came with your SCSI software drivers for information on installing the appropriate drivers and preparing your SCSI hard-disk

drive for use.

Back to Contents Page

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at

the next system start-up:

ALERT! Cover was previously removed.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting

the chassis intrusion detector.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

Keine Kommentare

Dell Precision 220 Bedienungsanleitung Seite 37