Dell Dimension 8300 Bedienungsanleitung PDF herunterladen (Seite 37)

1. Transfer components from the existing system board to the replacement system board:

a. Remove the memory modules and install them on the replacement board.



b. Remove the heat-sink assembly and microprocessor from the existing system board and transfer them to the replacement system board.

2. Configure the settings of the replacement system board.

3. Set the jumpers on the replacement system board so they are identical to the ones on the existing board.



4. Orient the replacement board by aligning the notches on the bottom to the tabs on the computer.

5. Slide the system board assembly toward the back of the computer until it clicks into place.

6. Replace any components and cables that you removed from the system board.

7. Reconnect all cables to their connectors at the back of the computer.

8. Close the computer cover.



9. Connect your computer and devices to electrical outlets, and turn them on.



Back to Contents Page



CAUTION: The microprocessor package and heat-sink assembly can get hot. To avoid burns, ensure that the package and assembly have had

sufficient time to cool before you touch them.

NOTE: Some components and connectors on the replacement system board may be in different locations from the corresponding connectors on the

existing system board.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 48 49

Keine Kommentare

Dell Dimension 8300 Bedienungsanleitung Seite 37