
Hardware Installation 15
9
Connect the cable from the external enclosure to the adapter. See Figure 3-2.
NOTE: The external cable can be connected to either of the two external connectors.
Figure 3-2. Connecting the Cable From the External Enclosure
10
Reconnect the power cable(s) and network cables, and then turn on the system.
NOTE: Ensure that you do not connect a hard disk and tape drive to the same SAS 5/iR Adapter.
NOTE: For information on connecting your SAS 5i/R controller to a tape drive see your system’s
Hardware Owner’s Manual.
NOTE: Installing an operating system on a disk attached to the SAS 5/E is not supported.
1 cable from the external enclosure 2 connector on the adapter
2
1
KD534bk1.book Page 15 Monday, April 2, 2007 4:37 PM
Kommentare zu diesen Handbüchern