Dell PowerVault 124T Bedienungsanleitung Seite 60
- Seite / 66
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Front Panel Error Types
EA
LCD Busy Error
Possible LCD controller problem, software error, or communication error.
l Power cycle the autoloader.
l Run the Random Moves test.
l If all previous steps fail, see Contacting Dell.
EB
LCD Goto Error
EC
Login/Password Error
Incorrect login from front panel.
l Use correct login/password.
ED
Socket Error During SNTP
Barcode Error Types
F0
Bar Code Init Error
l Remove magazines and inspect cartridges. Verify that valid barcode labels are being used on all
cartridges, and re-insert the magazines.
l If barcode labels are not being used, disable the barcode reader through the Operator Control Panel
or Remote Management Unit.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
F1
Bar Code Hardware Error
F2
Bar Code Baud Rate Error
F3
Bar Code Handshake Error
F4
Bad/Noisy Response From Bar
Code Reader
F5
Checksum Failed
Incomplete barcode label or barcode checksum failed.
l Repeat test with new cartridge or label.
l If problems recur with the original cartridge or label, replace.
l If all previous steps fail, see Contacting Dell.
F6
Barcode No Read
Barcode label not present.
l Apply valid barcode label to cartridge, or disable the barcode reader through the Operator Control
Panel or Remote Management Unit.
F7
Barcode Mismatch Error
l Power cycle the autoloader.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
F8
Barcode Duplicate Label Error
Duplicate barcode.
Diagnostic Error Types
F9
Diagnostic Test Failure
l Power cycle the autoloader.
l Re-run the failing diagnostic test.
l If all previous steps fail, see Contacting Dell.
FA
Diagnostic Error, Drive
Reporting Write Protect
l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
FB
Diagnostic Error, Cleaning Tape
Inserted
FC
Diagnostic Load Tape Prompt
This is a prompt to manually load a cartridge as required for test.
FD
Diagnostic Unknown Tape
Format
l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
FE
Diagnostic Invalid Configuration
This is an indication that a minimum of two pieces of media are required for test.
l Insure at least two cartridges are present in the autoloader and re-run the failed test.
- Notes, Notices, and Cautions 1
- User's Guide 2
- Setting Ethernet 3
- Setting the Subnet Mask 4
- Setting an IP Gateway 4
- Setting the SNMP Server 4
- Setting the Time 5
- Barcode Reader 6
- SCSI Barcode Length 6
- Setting Magazines 6
- Setting Security 6
- Setting Passwords 7
- Setting the Security 18
- Stopping a Diagnostic Test 18
- Front Panel Diagnostic Tests 18
- RMU Diagnostic Tests 19
- Technical Assistance 20
- AutoTech Service 21
- Product Information 22
- Problems With Your Order 22
- Before You Call 23
- Installation Overview 24
- Installation Preparation 24
- Host Bus Requirements 24
- Accessories 24
- Choosing a Location 24
- UL Requirements 25
- Bar Code Reader 25
- Product Overview 25
- Unpacking the Autoloader 26
- Tape Drive Device Driver 29
- Autoloader Device Driver 29
- Overview 31
- Enter Passwords 32
- Using Cartridges 33
- Ejecting a Single Cartridge 34
- Ejecting a Magazine 35
- Installing a Magazine 35
- Running an Inventory 37
- Viewing Status Information 37
- Viewing Element Status 38
- Viewing Tape Drive Status 38
- Viewing Tape Drive Version 38
- Viewing Ethernet Information 38
- Configuration Page 41
- Compression 42
- Cleaning Tape 42
- Setting the Magazines 42
- Setting the System Time 43
- Setting Network Options 43
- Firmware Page 45
- Library Operations Page 46
- Back to Contents Page 47
- Physical Specifications 48
- Tape Drive Specifications 49
- Checking for Errors 52
- Autoloader Logs 53
- TapeAlert Logs 61
- Packing the Autoloader 66
Verwandte Produkte und Handbücher für Computerhardware Dell PowerVault 124T
(151 Seiten)Grizzly G1066Z manuels
Manuels d'utilisation et guides de l'utilisateur pour Machines à broyer Grizzly G1066Z.
Nous fournissons des manuels en pdf 1 Grizzly G1066Z à télécharger gratuitement par type de document : Manuel de l'utilisateur
Kommentare zu diesen Handbüchern