Installation Guide 15
16
Align the left air baffle with the screw holes on the back of the sled cover.
17
Secure the left air baffle to the sled cover using the two M3 screws. Tighten the screws to
5.21 in-lb.
18
Route the power cables along the inside wall of the sled cover.
19
Secure the cables to the retaining clips.
Figure 1-18. Installing the Left Air Baffle
20
Replace the top cover.
NOTE: Be careful not to damage the twin axial cable on the back GPGPU card riser
when replacing the top cover.
21
Close the sled.
22
Replace the sled in the server enclosure.
1 left air baffle 2 M3 screws (2)
3 power cables 4 retaining clips (3)
C8220X_MIC5110P7120P_IG.book Page 15 Monday, August 12, 2013 5:42 PM
Kommentare zu diesen Handbüchern