
1-2 Installing or Replacing an ERA/O Card
www.dell.com | support.dell.com
Figure 1-1. Opening the System Covers
6
Remove the SCSI backplane board:
a Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch).
b Disconnect the diskette-drive interface cable from the FLOPPY connector on the
backplane board. See Figure 1-2.
c Disconnect the CD drive interface cable from the CD_ROM connector on the
backplane board. See Figure 1-2.
d Press the release latch in toward the backplane board and use the handle to pull
the board out of its connector and up out of the chassis. See Figure 1-2.
latch
optional security screw
right cover
left cover
K0238ebk0.book Page 2 Monday, February 24, 2003 2:53 PM
Kommentare zu diesen Handbüchern