Dell KVM 1082DS Bedienungsanleitung PDF herunterladen (Seite 34)

24xxx | Installationxxx

2 Rotate each rail 180° (item 2) and then reassemble each rail to the switch

(item 3).

3 Refer to the 1U rear-rack instructions to insert and remove the switch

assembly from the ReadyRails system.

NOTE: No blanking panel is required for this configuration.

0U RCS Installation

1 Align and assemble the 0U mounting bracket to the switch rails (Figure 2.7,

item 1). Tighten the thumbscrews (item 2).

2 Insert the mounting bracket hooks into the rack holes and push down until

the blue button pops out and locks the bracket into place.

Figure 2.7: 0U Installation

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 187 188

Keine Kommentare

Dell KVM 1082DS Bedienungsanleitung Seite 34