Dell KVM 1081AD/ KVM 2161AD Bedienungsanleitung PDF herunterladen (Seite 77)

OBWI Operationxxx | xxx69

To configure general network settings:

1 Click the Network tab, then click the General tab to display the SCS

General Network Settings screen.

2 Select one of the following options from the LAN Speed drop-down menu:

Auto-Detect, 10 Mbps Half Duplex, 10 Mbps Full Duplex, 100 Mbps Half

Duplex, or 100 Mbps Full Duplex.

NOTE: You must reboot if you change the Ethernet mode.

3 Select either Enabled or Disabled in the ICMP Ping Reply drop-down

menu.

4 Verify or modify the HTTP or HTTPS ports. The settings will default to

HTTP 80 and HTTPS 443.

5 Click Save.

To configure IPv4 network settings:

1 Click the Network tab, then click the Address tab to display the IPv4

Settings screen.

2 Click the IPv4 button.

3 Click to fill or clear the Enable IPv4 checkbox.

4 Enter the desired information in the Address, Subnet, and Gateway fields.

IPv4 addresses are entered as the xxx.xxx.xxx.xxx dot notation.

5 Select either Enabled or Disabled from the DHCP drop-down menu.

NOTE: If you enable DHCP, any information that you enter in the Address, Subnet, and

Gateway fields will be ignored.

6 Click Save.

To configure IPv6 network settings:

1 Click the IPv6 button.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 139 140

Keine Kommentare

Dell KVM 1081AD/ KVM 2161AD Bedienungsanleitung Seite 77