Dell PowerEdge M610x Bedienungsanleitung PDF herunterladen (Seite 3)

Processor Installation 3

Information Update on Processor Installation

Removing a Processor

WARNING: Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this

procedure, review the safety instructions that came with the system.

Prior to upgrading your system,

download the latest system BIOS version

from support.dell.com and follow the instructions included in the

compressed download file to install the update on your system

Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet. When disconnected from AC power,

press and hold the power button for 3 seconds to fully drain the system of

stored power prior to removing the cover.

NOTE: It is recommended that you always use a static mat and static strap while

working on components in the interior of the system.

Open the system. See "Opening the System" in the

Hardware Owner’s

Manual

Remove the cooling shroud. See "Removing the Cooling Shroud" in

the

Hardware Owner’s Manual

WARNING: The heat sink and processor are hot to the touch for some time after

the system has been powered down. Allow the heat sink and processor to cool

before handling them.

CAUTION: Never remove the heat sink from a processor unless you intend to

remove the processor. The heat sink is necessary to maintain proper thermal

conditions.

Release one of the heat-sink release levers or remove the screws from

the corners of the heat sink. See your

Hardware Owner’s Manual

for a

system-specific illustration. See Figure 1-1.

Wait 30 seconds for the heat sink to loosen from the processor.

Release the other heat-sink release lever.

Gently lift the heat sink off of the processor and set the heat sink aside

upside down (thermal grease side facing up).

1 2 3 4 5 6 7 8 ... 69 70

Keine Kommentare

Dell PowerEdge M610x Bedienungsanleitung Seite 3