Dell PowerEdge M605 Bedienungsanleitung PDF herunterladen (Seite 41)

Configuration Guide 39

Before You Begin

Network Information

You can configure your I/O switch modules using the CMC, as outlined in

"Configuring a Switch Module Network Ethernet Port Using the Web-Based

Interface

" on page 39

(the default IP address for the CMC is 192.168.0.120),

through the CMC CLI via serial console redirection, direct access to the I/O

module’s serial port (if supported), or using the I/O module’s default IP address

(if supported).

Switch Modules

Configuring a Switch Module Network Ethernet Port Using the

Web-Based Interface

You can use the CMC Web-based interface to configure an I/O module’s

Ethernet port.

NOTE: Use this procedure to configure the switch’s out-of-band Ethernet port. The

switch’s in-band management IP address is configured through the switch’s

external ports. These two IP addresses must be different, and on different

networks.

NOTE: To change settings on the I/O module configuration page, you must have

Fabric Administrator privileges for the particular Fabric in which the module is

installed.

NOTE: The network IP address set on the I/O module by the CMC is not saved to a

configuration file. To save the IP address configuration permanently, use the

connect switch-n RACADM command, or use a direct interface to the I/O

module GUI.

NOTE: Do not attempt to configure I/O module network settings for Ethernet

passthrough or Infiniband switches.

Using the Web-Based Interface" on page 25.

Select

I/O Modules

in the

Chassis

menu in the system tree.

Select the

Setup

tab. The

Configuring

I/O Modules Network Settings

page appears.

U003Cbk0.book Page 39 Wednesday, July 30, 2008 12:19 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 231 232

Keine Kommentare

Dell PowerEdge M605 Bedienungsanleitung Seite 41