Dell PowerVault 124T Bedienungsanleitung PDF herunterladen (Seite 13)

adhering to the cartridge at any point other than the designated label area.

3. Fully insert the cartridge into the slot.

When pushing the cartridge into the slot, you will feel a small resistance (detent) until the cartridge is properly latched into the slot. All

forward progress stops when the cartridge is fully inserted.

You can remove a cartridge in the same manner as you insert it. Use the white thumbwheels to center the desired slot(s) in the openings on the

side of the magazine. Do not rotate the magazine by inserting your hand and pushing the cartridge carriers. Using your thumb and index finger, pull

out the cartridge. You will feel a small resistance, but continue to pull the cartridge until it comes free.

Running an Inventory

The autoloader automatically runs an inventory whenever you power it back on or insert a magazine. An inventory checks each magazine slot, the

drive, the picker, and the media door (mailslot) to determine if a cartridge is present. If so, it also reads the bar code label, if available. If you need

to run an inventory in addition to this, you can do so manually.

The following show s approximate autoloader startup times with varying tape cartridge magazine configurations:

Magazine Fully Populated

(with Bar Code Labeled Media)

Bar Code Reader Startup Time

(Min:Sec)

Left Magazine only Enabled

Disabled

3:40

1:40

Right Magazine only Enabled

Disabled

3:40

1:40

Both Magazines Enabled

Disabled

4:15

1:40

NOTE: No bar code labels can be read if there is a tape in the picker.

To perform an inventory manually:

1. From the main menu, scroll to Commands, and then press Enter.

2. From the Commands submenu, scroll to Inventory, and then press Enter. The autoloader scans the bar codes of all the cartridges present.

Viewing Status Information

From the scrolling menu on the LCD, you can view the autoloader status, firmware version, element status, tape drive status, tape drive version,

and Ethernet information.

Viewing PowerVault 124T Autoloader Status

The autoloader status provides information about: whether a magazine is installed or not, SAS connection status, Ethernet connection status, and

whether the bar code reader is enabled or not.

To view the autoloader status:

1. From the main menu, scroll to Status, and then press Enter.

2. From the Status submenu, scroll to Autoloader, and then press Enter.

3. From the Autoloader submenu, scroll to Status, and then press Enter. A list of messages similar to the following appears:

Magazines

L=* Asterisk indicates the left magazine is present.

R=* Asterisk indicates the right magazine is present.

BC Reader

Yes Bar code reader enabled

No Bar code reader disabled

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 72 73

Kommentare zu diesen Handbüchern

Keine Kommentare

Dell PowerVault 124T Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Dell PowerVault 124T