Multicast Commands 661
Syntax
ip multicast staticroute
sourceipaddr mask rpfipaddr metric
vlan
vlan-id
no ip multicast staticroute
sourceipaddr
•
sourceipaddr
—
IP address of multicast packet source.
•
mask
—
IP mask of multicast packet source.
•
rpfipaddr
—
IP address of next hop toward source.
•
metric
—
Cost of route entry. (Range: 0-255)
•
vlan-id
—
Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example creates a static route which is used to perform RPF checking in
multicast packet forwarding.
console(config)#ip multicast staticroute 224.5.5.5 255.255.255.255
10.1.1.1 5 vlan 15
ip multicast ttl-threshold
Use the
ip multicast ttl-threshold
command in Interface Configuration mode to apply a
ttlvalue
to a routing interface.
ttlvalue
is the TTL threshold which is applied to the multicast Data packets
forwarded through the interface.
Syntax
ip multicast ttl-threshold
ttlvalue
no ip multicast ttl-threshold
ttlvalue
•
ttlvalue
—
Specifies TTL threshold. (Range: 0-255)
Default Configuration
This command has no default configuration.
Kommentare zu diesen Handbüchern