Dell POWEREDGE M1000E Bedienungsanleitung PDF herunterladen (Seite 10)

Installation and Basic OperationRev 1.0

2.4 LED Indicators

2.4.1 System LEDs

The system status LEDs indicate whether the PTM is receiving power from the chassis, and the

state of the PTM.

There are two system LEDs on the end of the module. The LED indications and meanings are

explained in the figure and table below.

Figure 5: Indicator LEDs

Table 4 - PTM states and LED configurations:

2.4.2 Port LEDs

The PTM has two I/O LEDs per port. The I/O LEDs are located on the I/O panel. The green LED,

when lit, indicates that the driver is running and a valid physical connection between nodes exists.

If the green LED is blinking, it indicates a problem with the physical link. The yellow LED when

lit, indicates a valid data activity link, this is the logical link. The yellow LED illuminates when the

LED

Module Status

Indication Status Power

OFF OFF OFF

OFF ON Boot in Progress

PTM not ready

Blinking Blue

BLINKING BLUE ON The CMC is identifying

the newly installed PTM

ON BLUE ON PTM is on and operating Normally

ON or BLINKING

Yellow

ON FW update is in progress or

Fault in System

Self-diagnosed

ON or BLINKING

Yellow

OFF Fault in System

CMC-detected

The IO Module is on and

ready when this LED is

green.

This LED can be blue or Yel-

low. A fault is indicated when

the Yellow LED is blinking.

See Table 4.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Keine Kommentare

Dell POWEREDGE M1000E Bedienungsanleitung Seite 10