Dell 3360 Bedienungshandbuch

Dell Vostro 3360Owner's ManualRegulatory Model: P32GRegulatory Type: P32G001

4. Remove the SIM card from the SIM-card holder.Installing the SIM Card1. Place the SIM card into the SIM-card holder.2. Slide the SIM card holder tog

Installing the Access Panel1. Place the access panel to its original position on the computer.2. Tighten the screw to secure the access panel to the c

Installing the Coin-Cell Battery1. Push the coin-call battery into its slot on the system board.2. Install the access panel.3. Follow the procedures i

3. Starting on the right side of the system, use a plastic scribe to pry up the keyboard from the computer.4. Flip the keyboard over and lay it on the

Installing the Keyboard1. Connect the keyboard cable to the system board.2. Place the keyboard back to its original position.3. Tighten the screw to s

5. Disconnect the quick launch board cable, the finger print reader cable, and the palmrest cable from the system board.6. Disconnect the power LED ca

7. Remove the screws that secure the palmrest to the front of the computer.8. Pry along the edges of the palmrest to release the palmrest.16

9. Lift the palmrest up and away from the computer.Installing the Palmrest1. Starting from the edges of the palmrest, press downwards on the palmrest

Removing the Battery1. Follow the procedures in Before Working Inside Your Computer.2. Remove the:a) access panelb) keyboardc) palmrest3. Disconnect t

Installing the Battery1. Place the battery into the battery bay.2. Replace and tighten the screws that secure the battery to the computer.3. Connect t

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

4. Lift the hard drive to disconnect the hard-drive cable.5. Disconnect the hard-drive cable from the hard drive and remove the hard drive from the co

Removing the Display-Hinge Cover1. Follow the procedures in Before Working Inside Your Computer.2. Remove the access panel.3. Remove the screws that s

Removing the Display Assembly1. Follow the procedures in Before Working Inside Your Computer.2. Remove the:a) access panelb) keyboardc) palmrestd) bat

e) access panel5. Follow the procedures in After Working Inside Your Computer.Removing the Display Bezel1. Follow the procedures in Before Working Ins

Installing the Display Bezel1. Align the display bezel with the display assembly and gently snap it into place.2. Install :a) display hinge coverb) ba

5. Flip the display panel from the display assembly.6. Place the display panel with its front facing down to access the display and camera cables atta

7. Pull out the plastic tab to disconnect the display cable from the display panel.8. Remove the camera cable from the display panel.26

Installing the Display Panel1. Place the camera cable on the back of the display panel.2. Connect the display cable to its connector on the display pa

Installing the Camera Module1. Connect the camera cable to the camera module and place the camera module to its original position on the display assem

Installing the Fan1. Connect the fan cable to the system board.2. Tighten the screws to secure the fan to the computer.3. Install :a) display assembly

ContentsNotes, Cautions, and Warnings...21 Working on

4. Remove the screws that secure the system board to the computer.5. Remove the hard-drive cable from its routing and flip the system board to access

Installing the System Board1. Connect the power connector cable to the system board.2. Thread the hard drive cable through its routing tabs.3. Tighten

4. Remove the heat sink from the system board,Installing the Heat Sink1. Tighten the screws to secure the heat sink to the system board.2. Install :a)

4. Release the speaker cables from their routing and remove the speakers from the computer.Installing the Speakers1. Place the speakers on the compute

Removing the Power Connector1. Follow the procedures in Before Working Inside Your Computer.2. Remove:a) access panelb) keyboardc) palmrestd) batterye

4. Remove the screws that secure the I/O board to the computer and remove it from the computer.Installing the I/O Board1. Connect the speaker cable an

36

3System SetupSystem Setup enables you to manage your computer hardware and specify BIOS‐level options. From the System Setup, you can:• Change the NVR

Keys Navigation<Enter> Allows you to select a value in the selected field (if applicable) or follow the link in the field.Spacebar Expands or co

MainL2 Cache Displays the processor L2 cache size.L3 Cache Displays the processor L3 cache size.Fixed HDD Displays the model number and capacity of th

Removing the Camera Module...

AdvancedSATA Operation Change the SATA controller mode to either ATA or AHCI.Default: AHCIAdapter Warnings Enables or disables adapter warnings.Defaul

Table 4. Security OptionsSecuritySet Service Tag This field displays your system's service tag. If the service tag is not already set, this field

Updating the BIOS It is recommended to update your BIOS (system setup), on replacing the system board or if an update is available. For notebooks, ens

NOTE: If the password jumper is disabled, the existing System Password and Setup Password is deleted and you need not provide the system password to l

44

4DiagnosticsIf you experience a problem with your computer, run the ePSA diagnostics before contacting Dell for technical assistance. The purpose of r

Turns on steadily or blinks to indicate battery charge status.Turns on when wireless networking is enabled.Battery Status LightsIf the computer is con

Beep Description Possible Cause/Troubleshooting Steps• reseat the memory if an additional memory is available• install that memory if the issue persis

48

5SpecificationsNOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start (Start icon) → Help

1Working on Your ComputerBefore Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage an

Feature DescriptionVostro 3460 / Vostro 3560 Conexant CX20672-21ZStereo conversion 24-bit (analog-to-digital and digital-to-analog)Interface:Internal

Feature Description• Bluetooth• WWAN (optional)Table 15. Ports and ConnectorsFeature DescriptionAudio:Vostro 3360 one stereo headphone/headset/audio-o

Feature DescriptionMaximum Brightness 200 nitsOperating angle 0° (closed) to 140°Refresh rate 60 HzMinimum Viewing angles:Horizontal 40°/40°Vertical 1

Feature DescriptionVostro 3360 14.8 VDCVostro 3460 / Vostro 3560 11.1 VDCTemperature range:Operating 0 °C to 35 °C (32 °F to 95 °F)Non-Operating –40 °

Table 21. PhysicalFeature DescriptionVostro 3360 Vostro 3460 Vostro 3560Height 19.20 mm (0.75 inch) 30.10 mm (1.18 inches)32.50 mm (1.27 inches)Width

6Contacting DellNOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill,

6. Close the display and turn the computer upside-down on a flat work surface.NOTE: To avoid damaging the system board, you must remove the main batte

CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer.3. Replace the battery.4. Connect

8

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Recommende